Wexxar WF30 Fully Automatic Case Former

The WF30 fully automatic case former / case erector, which forms up to 30 cases per minute, easily handles the common imperfections in corrugated that can disrupt the forming process. This remote demand-controlled machine will effortlessly open and form your RSC, HSC or CSSC cases at 30 CPM. The WF30 has re-invented toolless set-up, offering simpler, "user obvious" features that mean a quick and easy case size adjustments for packaging lines. The WF30 is available for pressure sensitive tape case sealers or hot melt glue forming.

The Shorr Packaging Difference - Complete, Professional Support for Case Erector Selection, Installation, Service, and Parts

Case Erector Selection. Our packaging equipment specialists are factory trained and have field experience across a wide range of industries. We help you select a carton erector system that meets current and future specifications, allowing you to increase productivity and reduce operating costs.

Case Erector Installation. A smooth installation requires careful attention and the experience to anticipate potential snags before they occur. Our service technicians have installed hundreds of case erectors in virtually all packaging line environments. We take the time to make your transition as smooth as possible.

Case Erector Service and Parts. Our Packaging Equipment Service Department is available 24/7 for operator training, scheduled service, emergency service calls, and replacement parts. All service technicians are factory certified and dedicated to making sure your case sealers run at peak performance.

Wexxar WF30 Specifications and Key Features

• Speed - Maximum 30 cases per minute (CPM)
• Size maximum - L: 24 x W: 17 x D: 16.5 Maximum E = 25
• Size minimum (Smaller/Custom sizes available by request) - L: 6 x W: 5 x D: 3.5 Minimum E = 6
• Positive Case Squaring System - Lines up and squares the case during sealing, creating visually appealing case output
• Single Push Transport System - Combines linear bearing guides with a mechanically adjustable case pusher for case squaring
• Dekka high performance tape head case closure system is standard
• Precision folded and sealed cases around the clock
• Positive case opening without vacuum easily accepts marginal quality corrugated board
• Large case feed magazine
• Corrosion-resistant, inline construction
• U.L. listed electrical panel
• Simple 10 minute size changeover
• Interlocked safety guarding
• Pin & Dome - As flat case blank is injected into the two facing plates, the pins goes into the flutes and the dome pinches the corrugated tightly. The two plates then open to 90 degrees to perfectly square the case. Since no compressed air is used in this process, it greatly decreases contamination and is more durable than vacuum cups which can clog and wear.
• Safety & Ergonomic Features - Floor level tending reduces strain; every machine Wexxar builds is fully guarded from in-feed to out-feed, interlocked safety guarding throughout the machine; easily accessed control and assemblies; palm e-switches located on both sides.
• Dynamic Flap Folding - Wexxar case formers have a dynamic flap folding system. As long plow rails aren't used, the overall length of the machine is significantly more compact. All four of the flaps are power folded in one position.

Related Case Erecting Equipment

Combi 2EZ Case Erector and Bottom Sealer
Combi Ergopack Hand Packing System
Combi DP Drop Packer with Integrated Case Erector
Combi DPI Drop Packer with Independent Case and Product Feed
Combi Alphapack Compact Pick and Place Case Packer
Wexxar WF10 Fully Automatic Case Former

Visit Our Wexxar Case Erecting Equipment Center
See Our 3M Carton Sealing Tapes